White wall lamp with switch | zangra

white adjustable wall lamp with switch

albert.w
$137.98
x
x
- +

shipped within 1-2 days

ZANGRA SAYS TECHNICAL DESCRIPTION

Albert wall lamp with adjustable shutter

This slim designed wall lamp with its pivoting shutter by zangra has been named Albert. Since the whole front part can rotate, you can decide to direct the light more upwards or downwards. Albert has a discreet switch, but it can also be connected to the switch of the room. Albert has a G13 lampholder into which a 60 cm long T8 LED bulb is inserted.


What is T8 LED bulb ?

A T8 LED bulb is a 26 mm diameter tube. There are 2 pins at both ends of this tube. The lamp holder is a G13 fitting because the two pins are 13 mm apart. A T8 LED tube replaces the well-known classic neon tubes as it is more energy efficient.

Is the light bulb included?

Yes, the light bulb is included when you buy this light. Take into account that each light needs a specific type of light bulb. You will find the kind of light bulb that it requires under the "Technical Description" tab.

What does the IP value mean on a light fitting?

All light fittings are classified according to their IP value. These IP values (International Protection or Ingress Protection) indicate the degree of protection of the light fitting against dust and moisture. The IP value consists of two digits: the first digit indicates the level of protection against dust; the second, the level of protection against moisture. The higher the IP value, the higher the protection. Check this diagram to see the different existing IP values.
 

What does the IP20 value mean on this light fitting?

IP20 means that the light fitting:
2: is protected against the intrusion of solid particles with a dimension greater than 12.5 millimetres.
0: has no protection against water penetration. This light fitting can be installed indoors, but not in wet areas.
It is not recommended to install this light fitting outdoors. A device with an IP20 value is not protected against dust or moisture. A light fitting marked IP20 may have holes to prevent overheating. However, the lamp is protected against contact with objects larger than 12.5 mm, such as a hand or finger.
This model is suitable for indoor use, but not outdoors.

Are the screws included?
No screws are supplied, as the type of screw depends on the material of the wall or ceiling (concrete, brick, plasterboard, wood).
You need a different type of screws depending on each material.