outdoor or bathroom raw brass pendant light - IP44

1. Above a dining table
Above a dining table, lower the pendant lamp so that it is up to 60 to 70 cm above the table. This means you won’t be blinded when you eat and won’t hit your head when you get up. The height indicated corresponds to the distance between the top of the table and the lowest part of the suspension light. The light should end up approximately at your eye level when you are standing, and you’ll see the underside of the light when you are sitting. You need to ensure that the light diffused by the pendant lamp illuminates the entire table.
2. Above a coffee table
A pendant lamp placed above a coffee table should be placed higher than those installed above a dining table so that you do not hit your head.
3. In the middle of a room
You should leave about 210 cm between the floor and the lowest part of the pendant lamp so that tall people do not hit their heads. If it is hung above a piece of furniture or in a corner, it can go down lower.
4. Above the kitchen worktop
Hand the light at least 180 cm from the floor or between 75 and 85 cm from your worktop or countertop. Don't hang your suspension too high, so you don't have to look at the light all the time, but it shouldn’t be too low either as it might not illuminate the whole worktop.
5. On each side of a mirror in the bathroom
If you want to hang two pendant lamps on each side of a mirror, they are best positioned according to the average eye height of your family members. It is also recommended that the two suspension lights are not more than 70 cm apart so that the face is sufficiently illuminated.

Brass is an alloy consisting predominantly of zinc and copper. Brass is significantly more yellow than pure copper and bronze. It is a material that has always been appreciated for its resistance and its colour close to that of gold.
Brass resists moisture and does not rust, and is easy to maintain. Over time, the glossy surface will tend to oxidize naturally and become verdigris (greyish-green). This is a natural process of brass ageing and does not constitute grounds for complaint or is something covered by the warranty.

All light fittings are classified according to their IP value. These IP values (International Protection or Ingress Protection) indicate the degree of protection of the light fitting against dust and moisture. The IP value consists of two digits: the first digit indicates the level of protection against dust; the second, the level of protection against moisture. The higher the IP value, the higher the protection. Check this diagram to see the different existing IP values.

What does IP44 mean?

The light bulb is not included when you buy this light. You will find here the whole selection of LED, incandescent, stick and halogen light bulbs. Take into account that each light needs a specific type of light bulb. You will find the kind of light bulb that it requires under the "Technical Description" tab.

No screws are supplied, as the type of screw depends on the material of the wall or ceiling (concrete, brick, plasterboard, wood).
You need a different type of screws depending on each material.

E27 stands for the type of the fitting of a lamp. E27 stands for a 27 mm diameter thread. "E" stands for Edison thread. So you always have to put an E27 light bulb in a fixture with an E27 fitting. E27 is the standard in England and most European countries.
The early light bulbs (remember them?) had a similar screw thread.
Be careful though, because there are also countries where E26 bulbs are the norm (for example in the United States).
If you would like to know which standard applies in your country, check out this page.
Check out here the complete collection of E27 light bulbs by zangra.